C_type_Piston loose new settings

[seipv]

When I use standart C_type_Piston is loose the new settings, for example length of cylinder, also when simulate the movement not stop at the end of the stroke.

Expected behavior
cylinder should not move more than the physical length.

[robbr48]

I am not sure I understand the problem. Can you exaplain it more in detail, and perhaps propvide a model file (.hmf)?

[seipv]

If the length is 150mm there should not be possible under simulation cylinder to extent more that specify stroke. See picture from simulation.

hmf file type seems cannot be attached here.

[seipv]

the problem solves with use of HydraulicPistonMload istead of HydraulicPiston. Application is gear flow divider for cylinder synchronization

[robbr48]

The end-of-stroke limtiation in the HydraulicCylinderC component is modelled as a very stiff spring, so technically it is possible to push it beyond the stroke limit under certain cirumstances (no leak with prescribed flow, or very high pressures). If you want a guaranteed stop I suggest you control it by using the maximum and minimum position parameters in the TranslatioanlMass component - these are strict algebraic constraints.